Fuel pump Suntec D67C 7284-3

Suntec D67C 7284 gear-type liquid oil pump is specifically adapted for fuel oil with a viscosity of up to 75 cSt and for operation at elevated fuel temperatures up to 90 °C. Suntec D67C7284 oil pump application: Suntec oil pump is intended for use with fuel oil and medium-viscosity liquid fuels. It can be operated in single-pipe or two-pipe systems. The design requires the use of an external shut-off solenoid valve. Suntec D 67 C 7284 oil pump adjustment: The gear set draws fuel from the tank through an integrated filter and delivers it to the pressure regulating valve. The fuel is then supplied to the nozzle line. Fuel that does not pass through the nozzle is discharged through the valve into the return line in a two-pipe system. In a single-pipe system, the fuel is returned to the suction side. In this case, the bypass plug must be removed from the return line and the return port must be closed with a steel plug and washer. In two-pipe systems, air is vented automatically. In single-pipe systems, air is discharged through the nozzle line during start-up. The bypass hole in the nozzle line coupling allows air to pass through the nozzle line without opening the pressure regulating valve. During the initial start-up, air venting can be accelerated by loosening the pressure gauge port plug. Due to the presence of the bypass hole in the nozzle line coupling, the pump has no shut-off function. The shut-off function must be provided by an external solenoid valve. Models of size 45 and 55 are equipped with a piston featuring a special cavity to prevent pressure build-up in the nozzle and suction lines during pump shutdown caused by thermal expansion of fuel heated by the nozzle line heater. Suntec D67C7284 oil pump technical data: Mounting: hub or flange mounting according to EN 225 Connection thread: cylindrical according to ISO 228/1 Suction and return line: G¼" Nozzle outlet: G⅛" Pressure gauge port: G⅛" Vacuum gauge port: G¼" or G⅛" Valve function: pressure regulation without shut-off function Screen filter: open area 12 cm2 Filter mesh size: 530 µm Shaft: Ø 8 mm according to EN 225 Bypass plug: installed in the return line for two-pipe systems; removed with a 4 mm hex key for single-pipe systems Nozzle pressure range: 10–28 bar Factory pressure setting: 14 bar Operating viscosity: 2–75 mm2/s (cSt) Fuel temperature in pump: 0–90 °C Inlet pressure: max. 2 bar Outlet pressure: max. 2 bar Suction lift: max. 0.45 bar vacuum Nominal speed: up to 3600 rpm Torque D 67: 0.12 N·m