Delavan Protek Valve 60101-001

The Delavan Protek Valve 60101-001 is listed under oil filters, coils, tubes and hoses. Parts of this type are installed in the fuel supply line between the tank and the oil pump, or sometimes integrated into the pump body. They control the flow of oil to the nozzle and, in solenoid-operated versions, provide the rapid shut-off that the burner control requires for a clean flame-out. Such valves are selected according to port size, pressure rating, coil voltage and resistance, and thread type. The connections must match the existing pipework, and the electrical data must be compatible with the burner control that energises the solenoid. When replacing a valve of this class, check the direction of flow marked on the body and the pressure range it is designed for. A mismatch in pressure rating can cause leakage or failure to open fully. The coil should be tested with a multimeter before installation; if the solenoid coil is open-circuit or shorted, the burner may not cut off fuel completely, leading to after-drip or delayed ignition. The shaft seal and O-rings should be inspected for hardening or cracking, especially if the oil has been preheated. The category also includes filters and coils that work alongside such valves. The filter protects the valve and the nozzle from debris, while the coil is the replaceable electrical component. If the valve body is sound but the solenoid fails, a matching coil can be obtained separately. Always verify the manufacturer code – 60101-001 and 345.322.001 – against the original part before ordering.