Cable Baltur 0005130111

This cable is a Baltur spare part, listed under catalogue article 156.292.001 and manufacturer codes 0005130111 and 156.292.001, in the Cables category. Cables, connectors and harnesses of this type carry low-voltage control signals and mains supply between the burner control board and components such as the fan, gas valve, ignition transformer, flame detector, and sensors. They are matched by connector series, pin count, pitch and keying rather than by the function of the circuit they serve, so the correct replacement must have the same connector configuration and conductor properties as the original. When selecting a cable for a burner, the key parameters are the connector series and pin count on each end, the conductor cross-section (to handle the required current without excessive voltage drop), the insulation temperature class (to withstand the ambient heat near the burner), the overall length, and the terminal type (whether pre-crimped contacts, loose wires, or a moulded connector). A poor connection in any connector can reproduce almost any electrical fault — intermittent flame signal, false lockout, or erratic modulation — so the cable and its connectors are a routine suspect during fault finding. Replacing a cable with one that matches only the pin count but uses a different connector series or keying will not fit or may cause intermittent contact.