Cavo di ionizzazione e accensione Weishaupt da 480 mm We2301101108-2

Cable kit from manufacturer Weishaupt is a double harness that combines two critical cables: ignition (high-voltage) and ionization (signal). It is designed to connect the electrode group to the control system of an industrial burner and provides both fuel ignition and continuous flame monitoring. Failure of this component (insulation breakdown or breakage) usually results in the burner not starting at all or going into alarm after a few seconds. Technical specifications: Parameter Value Part numbers We2301101108-2, 23011011082, 972.298.021 Manufacturer Weishaupt (Germany) Cable length 480 mm Ignition cable Angled plug Ø4 mm (to transformer) — straight plug Ø4 mm (to electrode) Ionization cable Straight plug Ø4x15 mm (to burner control) — plug Ø6 mm (to electrode) Insulation Polymer, heat-resistant, resistant to high temperatures and mechanical stress ⚙️ What does this kit do? This cable performs two different but equally important functions in the burner: Ignition cable: High voltage (up to 10 kV) is supplied from the ignition transformer to the electrode via this cable. The resulting spark ignites the fuel-air mixture. Ionization cable: A weak microcurrent (ionization signal) is transmitted from the ionization electrode to the control unit (burner control) via this cable, confirming that the flame is burning steadily. ⚠️ When is replacement required? Damage to this cable is a common problem during burner operation. Replacement is necessary in the following cases: Burner does not start (no spark): Visible or hidden current leakage to the burner housing, due to which the breakdown does not reach the electrode. Burner starts and immediately shuts down: Damage to the ionization cable leads to loss of the weak signal from the flame sensor.