Honeywell ASY784 s700/s800 Anschlussset ohne Kabel

This connector kit, listed under sensor components, is used to interface temperature sensors (such as NTC probes) or other field devices with the control board of a burner or boiler. It comes without a cable, meaning the installer must terminate the sensor leads into the connector housing, selecting the appropriate cable type and length for the installation. Parts of this type are selected primarily by the connector geometry and pin arrangement, which must match the socket on the control board, and by the number of contacts required. When replacing a connector kit, check that the contact retention and insulation rating are suitable for the sensor signal voltage and ambient temperature in the control panel. Ensure that the cable ends are stripped and crimped correctly to avoid intermittent contact, which can cause erratic modulation or fault codes. If the original installation used a specific cable diameter, verify that the connector’s cable gland or strain relief, if present, can accommodate the new cable.